Now plug in or replug your ESP32 adapter to your PC, so we could detect a new port. Change its alias if needed, and click 'Next'. Once everything is ready, enable the External device in the Virtual controller settings, and click on the icon in the lower-left corner (near 'Remap is OFF / Nothing is applied') to run the wizard.Ĭhoose the type of adapter you want to add, ESP32 Bluetooth adapter, in this case. For ESP32 wired connections, use USB 3.1 or lower, or use a USB hub to connect your ESP32 Bluetooth adapter.Here you can find drivers for M5Stack ESP32 Atom Matrix and for Generic ESP32 board. Make sure ESP32 board drivers are installed before using ESP32 Bluetooth adapter with reWASD.If you don't have a pre-made config, get one from reWASD Community, or try the PS4 Remote Play or Switch console config you have in reWADS after installation. A config that has an appropriate Virtual controller set up.Make sure to use the Detection mode to define and initialize all the devices properly.

A group of devices you want to control your External virtual controller.You should have a PC or laptop with reWASD installed and ESP32 board.Two types of ESP32 boards, which we recommend:īefore you start working with the ESP32 Bluetooth adapter wizard, we recommend that you have several things prepared in reWASD: They cannot be used as ESP32 Bluetooth adapters for reWASD, because they do not have Bluetooth classic and reWASD Bluetooth firmware will not work on them. Note that there are also other devices which have suffixes after 'ESP32', like 'ESP32-S2', 'ESP32-S3' etc. You are free to use any ESP32 device that has a serial port for connection to a PC, and it will work. What types of ESP32 boards do we support? You can then connect any device you want to remap and use with your laptop/PC and start remapping. After reWASD installs the firmware, you need to connect the ESP32 Bluetooth adapter to the target device. To achieve all of these capabilities, we have written our own firmware for ESP32, which installs when an adapter is added within reWASD. Additionally, users can use virtual amiibos in this setup with an ESP32 Bluetooth adapter. Users can use the ESP32 Bluetooth adapter to emulate an external virtual controller and gain access to all the features that reWASD provides on PlayStation 4, Nintendo Switch consoles, or other Bluetooth devices, such as tablets or mobile phones. As of version 6.5, reWASD supports ESP32 Bluetooth connections. The ESP32 is a low-cost and low-power microcontroller that has integrated Wi-Fi or Bluetooth capabilities.

Gamepad button mapper